Dmc20 Drive-Cliq Hub - Siemens SIMOTION D425 Manual

Spare parts/accessories

6.10 DMC20 DRIVE-CLiQ hub

Interface
Power Module Interface (PM-IF)
24 V electronic power supply
Encoder interface (HTL, TTL, SSI)
Only SSI encoders without incremental tracks may be operated.
Maximum DRIVE-CLiQ cable length
The 50 mm clearances above and below the components must be observed. The
ventilation openings may not be covered by connecting cables.
Additional references
You will find more information on the CUA31/CUA32 control unit adapter in the
SINAMICS S120 AC Drive
6.10 DMC20 DRIVE-CLiQ hub
Features
The DRIVE-CLiQ DMC20 Hub Module is used to implement point-to-point distribution of a
DRIVE-CLiQ line. With the DMC20, an axis grouping can be expanded with four DRIVE-
CLiQ sockets for additional subgroups.
The module is especially suitable for applications which require DRIVE-CLiQ nodes to be
removed in groups, without interrupting the DRIVE-CLiQ line and therefore the data
exchange.
The 50 mm clearances above and below the component must be observed.
Additional references
You will find detailed information about the DMC20 in the
Additional Components
78
CAUTION
Manual.
CAUTION
Manual.
CUA31
1
1
0
50 m
SINAMICS S120 Control Units and
Manual, 05/2009
CUA32
(V4.1 SP2
and higher)
1
1
1
100 m
D4x5