Terminal Board Tb30 - Siemens SIMOTION D425 Manual

Spare parts/accessories

6.3 Terminal board TB30

4. Connect the cable plug connector of the new battery to the mating connector in the
Figure 6-3
5. Hold the fan/battery module at an angle to the front with the open side facing up (battery
6. Push the plastic guide into the cutout on the underside of the control unit.
7. Tilt the fan/battery module up until the front latching device snaps into place.
Note
The fan/battery module may only be replaced when the device is in the power OFF state.
The battery should be replaced at least once every 3 years, and certainly whenever the
warning level is reached (see
Manual).
Delaying the replacement of the battery may result in the loss of retained data!
6.3 Terminal board TB30
Features of the TB30
The TB30 is a terminal expansion module that can be inserted in the D4x5.
The TB30 contains the following terminals:
72
fan/battery module and push the battery in.
Change the battery in the fan/battery module
visible).
The electrical connection between the fan/battery module and the control unit is made
automatically.
SIMOTION D4x5
Commissioning and Hardware Installation
D4x5
Manual, 05/2009