Table of Contents
Advertisement
Hardware Preparation and Installation
1
Remote Status and Control
The remote status and control connector, J4, is a keyed double-row
20-pin connector located behind the front panel of the MVME1600-
011. It connects to a user-supplied external cable and carries the
signals for remote reset, abort, the LEDs, and three general-purpose
I/O signals. This allows a system designer to construct a
RESET/LED panel that can be located remotely from the
MVME1600-011. This feature is similar to the remote connector
provided on the MVME167 and MVME187 Single Board
Computers; maximum cable length is 15 feet.
The general-purpose I/O signals include two TTL-level I/O pins
and one general-purpose interrupt pin which can also function as a
trigger input. The interrupt pin is level programmable.
Table 1-3 lists the pin numbers, signal mnemonics, and signal
descriptions for J4.
1-25
Advertisement
Table of Contents
