Table of Contents
Advertisement
MVME1603/1604 VMEmodule Installation
1
MVME1603/1604 VMEmodule Installation
!
Caution
!
Warning
1-38
MVME160x. Install two similar screws in the bottom (tabbed)
corners of the RAM104. Tighten the screws.
11. Reinstall the MVME1603/1604 assembly in its proper card
slot. Be sure the module is seated properly in the backplane
connectors. Do not damage or bend connector pins.
12. Replace the chassis or system cover(s), reconnect the system
to the AC or DC power source, and turn the equipment
power on.
With mezzanine boards installed and headers properly configured,
proceed as follows to install the MVME1603/1604 in the VME
chassis:
1. Attach an ESD strap to your wrist. Attach the other end of the
ESD strap to the chassis as a ground. The ESD strap must be
secured to your wrist and to ground throughout the
procedure.
2. Perform an operating system shutdown. Turn the AC or DC
power off and remove the AC cord or DC power lines from
the system. Remove chassis or system cover(s) as necessary
for access to the VMEmodules.
Inserting or removing modules with power applied may
result in damage to module components.
Dangerous voltages, capable of causing death, are
present in this equipment. Use extreme caution when
handling, testing, and adjusting.
3. Remove the filler panel from the card slot where you are
going to install the MVME1603/1604.
Advertisement
Table of Contents
