Star Micronics Star SCP700 Series Programmer's Manual page 79

Customer display commands (Combo mode only)
CODE
HEX
FUNCTION
CODE
HEX
FUNCTION
<ESC> "S"
1B 53
Start customer display
Subsequent data is sent through the customer display. Customer
display data is sent as follows.
This command is saved in the print buffer and retrieved from the
print buffer and executed in the same way as the other print data.
<ESC> "S" Customer display data
Through the customer display
This command is only effective in the combination mode and when
memory switch 0-8 = 0.
When the customer display is being used, the option RS232C I/F
communication conditions must be baud rate = 9699BPS, data
length = 8 bits, no parity, so set the dip switches accordingly.
<ESC> "G"
1B 47
End customer display
This command is regarded as the customer display data end code and
subsequent data is processed as print data. This command is saved in
the print buffer and retrieved from the print buffer and executed in
the same way as the other print data. This command is only effective
in the combination mode and when memory switch 0-8 = 0.
This command is only valid with the slip printer.
<ESC> "G"
75