Chapter 8: Automatic Cutter - Star Micronics Star SCP700 Series Programmer's Manual

Chapter 8: Automatic Cutter

1 The cutter operates in response to data commands. To enable cutter
operation, set Memory Switch #2-8 to indicate that the cutter is installed.
2 NEVER place fingers or metal objects in the cutter area.
3 If a jam occurs in the cutter area, switch off the power, use tweezers to
remove the jammed paper, then switch the power back on. The printer will
return the blade to the home position.
4 Never clean the cutter blade with alcohol or any other solvent, as this may
remove the blade's lubrication and shorten the blade life.
29