Star Micronics Star SCP700 Series Programmer's Manual page 14

10
To exit this mode, press the SLIP/RESUME button. The dot alignment adjust
mode setting is stored in the memory, a pattern using the selected setting,
followed by "Adjust Completed" is printed, and the printer ejects the slip paper.
Note:
If you press the SLIP/RESUME button without pressing the RECEIPT button
after entering the Dot Alignment Adjust Mode, the printer assumes that you do
not want make any settings, so it prints the message "Adjust Complete!" and
exits the mode.
If a paper feed error occurs during this mode, the printer ejects the paper and
this mode is cancelled.