Star Micronics NX-2415II User Manual page 90

If otherwise specified, this command is ignored. This command
becomes effective only after <ESC> "3" or <ESC> "J" is received.
The default base unit is set to 1/216".
Set line spacing
Mode ASCII
Decimal Hexadecimal
Both <ESC> "3" /?
27 51 )1
IB 33
n
Sets the distance the paper advances or reverses in subsequent line
feeds to n/180 inch, n/216 inch or n/360 inch (n/180 inch for the
Standard mode) according to the preceding base unit.
The value of n is between Oand 255. If n = O,in Standard mode the
line-feed distance is set to O, but in IBM mode this command is
ignored.
Set line spacing to n160inch or n172inch
Mode
ASCII Decimal Hexadecimal
Both
<ESC> "A" n
27 65 n
1B 41 n
In Standard mode, sets the distance the paper advances or reverses
in subsequent line feeds to n/60 inch, where n is between Oand 255.
If n = O,the line spacing is set to O.
In IBM mode, this command defines the distance the paper advances
or reverses in subsequent line feeds to n/72 inch, where n is between
1 and 85. The new line'spacing does not take effect until the next
<ESC> "2" command.
Execute dlSC> "A"
Mode ASCII
Decimal Hexadecimal
IBM <ESC> "2" 27 50 tB 32
Sets the line spacing to the value defined by the last preceding
<ESC> "A" command. Sets the line spacing to 1/6inch if there is no
preceding <ESC> "A" command.
81