Table of Contents
Advertisement
Printer test works, but printer does not print when attached to computer
IProbable Cause
I Action
I
Printer cable has a problem.
Make sure that the printer cable is correctly
connected at both ends, printer and com-
puter.
Problem with the application Refer to your application program manual.
program.
Printer sounds the audible alarm
\Probable Cause
I Action
This might indicate an error
or normal operation.
Check the status of the control panel indica-
tors and see "Conditions indicated by beep
tones" in Chapter 4.
Selected pitch or font is being changed
]Probable Cause
I
Action
Set your printer in Font/Pitch lock. See
"Pitch lock mode" and "Font lock mode" in
Chapter 4.
Printer does not feed paper
Probable Cause
Paper is jamming.
Adjustment lever is set in-
correctly.
Releaseleveris setincorrectly.
\Fanfold form isparked.
Action
Remove all forms and pieces of paper.
Check the setting of the adjustment lever.
See "Adjusting the printing gap" in Chapter
3.
Check the setting of the release lever. This
lever must be set to the back for cut-sheet
forms (.~ ), and forward for fanfold forms
( ~).
Unpack the fanfold paper.
48
Advertisement
Table of Contents
