Table of Contents
Advertisement
8**
DOT
ADJUSTMENT
SJjl'TI).J(J * * *
LQ
o:
111111111111111111111111111111111111
IH II
( SET/EJECT
'LQ
-1
:
;/ );/)
/////
!,(,
,11111111
!1111[1
11!
11111!
1111111111111
11141111111111
1
(PAPER FEED
'iLQ
0:
1111111111111111111111111 Hlllllllllllll
(
ONLINE
'DRAFT
o:
1111111111111111111111111 111111111111111
(PAPER FEED
%RAFT
+1 :
IIl!lltlllll
!1!1!1(111!11
1111111111111
II
111111{111!1!
11!111!1111111
1111111111111
(
SET/EJECT
'DRAFT
o:
1111111111111111111111111 111111111111111
(
ONLINE
*DRAFT
COND
O :
1111111111111111111111111 111111111111111
(
ONLINE
'GRAPHICS
o:
1111111111111111111111111
111111111111111
=
9
*$$ END *t*
Hexadecimal dump
This feature isusefulforprogrammers whoaredebuggingprintingprograms
and wantto seethe actual codes the printer is receiving. (Some computers
change the codes the programmer intended.)
Inthismode,all datareceived will beprintedinahexadecimal dumpforma~
ratherthan the control codes being actedon as command codes.
This mode is accessed by the following procedure:
1. While holding boththe (PAPER FEED) and(SET~JECT)buttons down,
turn power ON. A beep tone will be heard.
2. Begin printing. In place of the usual printout you will get a formatted
dump showing exactly what data the printer receives. Each line presents
sixteen characters, their hexadecimal codes to the left and printable
characters printed on the right.
3. At the end of the hexadecimal dump, set the printer off-line with the
(ON LINE) button. This is necessary to print the last line.
Advertisement
Table of Contents
