Table of Contents
Advertisement
Loading paper
1. Place a stack of fanfold paper behind and at least one page-length below
the printer.
2. Turn the printer's power OFF, and remove the printer cover.
3. Hold the fanfold paper by hand so that the rear side of the paper is facing
upwards, then set the end of the paper into the entry slot for cut-sheet
forms and load the paper into the printer.
Figure 7-13. Inseri the paper from the entry slot for cut-sheet forms
4. Pull the paper about one page towards the sprocket guides.
5. Adjust the spacing of thetractorunits by sliding them along the bar, using
the clamp lever at the side of each unit to release them and lock them in
position. The unit is released when the clamp lever is down and locked
when the clamp lever is up.
Clamp lever
Figure 7-14. Adjust the sprocket guides.
61
Advertisement
Table of Contents
