Table of Contents
Advertisement
6. Insert the paper stack into the Automatic Sheet Feeder.
The stack should not be more than 50 sheets of 20 lb paper.
If necessary, remove some sheets. The ASF may not perform satisfacto-
rily if it is overloaded.
7. Adjust the right paper guide to accommodate the width of the paper.
The guides should be adjusted to restrict the amount of horizontal play
while allowing the paper to slide up and down freely between the two
paper guides. The ideal distance between paper ream and paper guides is
0.25 mm (0.0 1")on both sides at the narrowest part of the paper guides.
8. Push the paper loading lever toward the rear of the printer.
1
I
Figure 7-9. Push the paper loading lever to hold the paper stack.
Now you are ready to start printing with the Automatic Sheet Feeder.
58
Advertisement
Table of Contents
