Table of Contents
Advertisement
Selecting the print color
Normally, the color printer prints with black even if the color ribbon is
installed.
Without the aid of software, you can change the printing color as follows:
1.
2.
3.
4.
Press the (
ON LINE
) button to set the printer off-line.
Press the (FONT) button and hold it down.
While holding them
button, press the ( SL Ad&' 1 ) button.
Each time you press the
button, one of the indicators of
FONT
or
PITCH
will blink to show the current color as shown below.
Release both buttons after you set the desired printing color.
If you want to save the selected color for later use, store it using the
Macro Definition.
NOTE:This function is valid only when the color ribbon is installed into the
color printer.
Store Macro Definition
You can store the current settings to the printer for later use with the
following procedure:
1. Press the(
ON LINE
) button to set the printer off-line.
2. Press the (FONT) button and hold it down.
3. While holding the (FONT) button down, press the (HiDI) button and
hold them down until you hear two beep tones.
4. Release both buttons at the same time after the two beep tones to store
the current setting.
If you release these buttons after three beep tones, the macro is cleared.
NOTE: You can store the following settings with this procedure.
l
Current Font and Pitch
l
Current auto-loading amount for cut sheet
l
Current auto-loading amount for continuous paper
l
Current auto-loading amount in ASF mode
Advertisement
Table of Contents
