Star Micronics NX-2420 Multi-Font User Manual page 70

Set base unit for line spacing
Mode ASCII Decimal
Hexadecimal
IBM
<ESC> "[" 'T'
<4>
<o>
27 91 92 4 0 1B 58 5C 04 00
<o> <o> <o> n
0 0 0
n 00 00 00 n
Sets the base unit for the line spacing commands, cESC> "3" and
<ESC> "J". If the value of n is 180, the base unit is set to l/l 80". If
the value of n is 216, the base unit is set to l/216". If otherwise
specified, this command is ignored. This command becomes effec-
tive only after <ES0 "3" or <ES0 "J" is received, The default
base unit is set to l/216".
Set line spacing to n/180 inch or n/216 inch
Mode ASCII Decimal Hexadecimal
Both <ESC>
"3"
n
27 51
n
1B 33
n
Sets the distance the paper advances or reverses in subsequent line
feeds to n/l80 inch or n/216 inch, where n is between 0 and 255. If
n= 0, in Standard mode the line-feed distance is set to 0, but in IBM
mode this command is ignored.
Set line spacing to n/60 inch or n/72 inch
Mode ASCII Decimal
Hexadecimal
Both <ESC> "A" n
27 65
n
IB 41 n
62
In Standard mode, sets the distance the paper advances or reverses
in subsequent line feeds to n/60 inch, where n is between 0 and 255.
If n =O, the line spacing is set to 0.
In IBM mode, this command defines the distance the paper ad-
vances or reverses in subsequent line feeds to
n/72
inch, where
n
is
between 1 and 85. The new line spacing does not take effect until the
next <ESC> "2" command.
'I