Table of Contents
Advertisement
Federal
Communications
Commission
Radio Frequency
Interference
Statement
This equipment has been tested
and
found to comply with the limits for a Class B digital device,
pursuant
to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection
against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio f
3
uency
energy
and,
if not installed and used in accordance with the instructions, may cause harmful inte etmce
to radio communications.
However, there is no guarantee that interference
will not occur in a particular
installation. If this equipment
does cause
harmful interference to radio or television reception, which can
be determined
by turning the equipment
off and at, the user is encouraged
to try to correct the
interference
by one or more of the following measures:
l
Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment
into an outlet on a circuit different from that to which the receiver is
connected.
l
Consult the dealer or an experienced
radiofl
technician for help.
Unauthorized
modifications
of this product by the user will void his authority
to operate the equipment
unless expressly approved by the patty responsible for compliance.
For compliance
with the Federal Noise Interference Standard, this equipment requires a shielded cable.
The above statement applies only IO prinkrs marketed in the USA.
Statement
of
The
Canadian
Department
of Communications
Radio Interference
Regulations
This digitalapparatus
does not exceed the Class B limits for radionoise
emissions from digital apparatus
set out in the Radio Interference
Regulations
of the Canadian Department
of Communications.
Le present appareil numerique
n'&nen pas de bruits radio&ctriques
depassant les limites applicables
aux appareils numeriques
de la classe B prescrites darts le Rtglement
sur le brouillage
radio&crrique
Cdicd par le minisbe
des Communications
du Canada.
The above statement applies only lo printers m&led
in Canado.
Trademark Acknowledgements
NX-2420, XB-2410, NX-2410, SPC-8K, SF-lODQ, RH-1OZ: Star Micronics
Co., Ltd.
IBM
PC,
PC-AT, PC-XT,
Proprinter
X24E, Proprinter
X24, PC-DOS: International
Business Ma-
chines Co
.
%
Microsoft
ASIC, MS-DOS: Microsoft
Corporation
LQ-860, LQ-850: Seiko Epson Corp.
NOTICE
l
All rights reserved. Reproduction
of any part of this manual in any form whatsoever
without
STAR's express permission
is forbidden.
l
The contents of this manual are subject to change without notice.
.
All efforts have been made to ensure the accuracy of the contents of this manual at the time of
~;e~;e$wever,
should any errors be detected, STAR would greatly appreciate being informed
.
The above notwithstanding,
STAR can assume no responsibility
for any errors in this manual.
0 Copyright 1990 Star Micronics Co., Ltd.
Advertisement
Table of Contents
