Table of Contents
Advertisement
Switch B-l:
Are you going to print on multi-part paper?
You can use up to 3-ply paper when this switch is ON. If you want to print
on 4-ply or 5-ply paper, set this switch to the OFF position.
Switch B-2:
Do you want the printer to stop printing at the end of the paper,
or to keep printing?
When this switch is OFF the printer ignores the paper-out detector and prints
down to (and beyond) the bottom edge. Otherwise leave it ON.
Switch B-3:
Do you want to advance paper automatically at the end of
printing?
You can select the Tear Off function with this switch OFF.
When using fanfold paper, the Tear Off function allows you to tear off one
sheet of paper without fully advancing the following sheet.
Switch B-4:
This switch is used for technical purpose only. Leave this
switch ON.
Switch B-5:
Which type of printing area do you want to use for single
sheets?
This printer can use two types of printing arca format for single sheets.
By putting the switch ON ("Type A"), the top of the first line of printing will
start l/6 inch from the top ofthe paper, and the printed area will end l/6 inch
from the bottom of the paper.
By putting the switch OFF ("Type B"), the first line of printing will start at
one inch from the top of the paper, and the printed area will end 6 mm from
the bottom of the printer.
-
Switches C-l and
C-2: Which print mode do you want to set?
These switches sclcct the default print pitch and the fonts as shown below.
Print Mode
C-l
c-2
1OCPI DRAFT
ON
ON
1OCPI HS DRAFT
ON
OFF
17CPI DRAFT
OFF
ON
1 OCPI
LQ
OFF
OFF
NOTE:
If you change these switches after you have stored the macro, these
settings will override the macro setting.
40
Advertisement
Table of Contents
