Table of Contents
Advertisement
ADJUSTING
THE PRINTING GAP
The distance between the print head and the platen can be adjusted to
accommodate different paper thicknesses. To make this adjustment, remove
the top cover. The adjustment lever is located at the left side of the printer
mechanism. Pushing the adjustment lever backwards narrows the gap;
pulling it forwards widens the gap.
There are six positions, and you can feel the lever clicking into each position.
The second position from the rear is the one most commonly used for single
sheets of paper. Try different positions until you get the best printing results.
(Do not set the lever out of the marked positions.)
Adjustment
lever
I
Figure I-18. Location of the adjustment lever
Advertisement
Table of Contents
