Wiring Diagrams - Sierra Wireless FX30S User Manual

Rev 2 Mar.18

Wiring Diagrams

In the following diagrams, FX30 refers to either FX30 and FX30S.
Always On Installation
For an Always On application, connect the wires as shown in
DC power source
DC power source
Figure 2-15: Always on installation
• Pin 1 (Power)—Use the red wire in the DC cable to connect Pin 1 to the
power source.
• Pin 2 (Ground)—Use the black wire in the DC cable to connect Pin 2 to
ground. See also Step 2—Mount and Ground the FX30S Chassis
page 12.
• Pin 3 (On/Off)—Connected to power
• Optional—I/O 1, I/O 2, and I/O 3
Note: See Table 3-10, WP8548 Radio Module Interface Mapping,
module GPIO and Linux interface mapping of pin 3, I/O 1, I/O 2, and I/O 3.
On/Off Installation
For an On/Off application, connect the wires as shown in
Figure 2-17.
DC power source
DC power source
On/Off switch
On/Off switch
Figure 2-16: On/Off Installation with switch
• Pin 1 (Power)—Use the red wire in the DC cable to connect Pin 1 to the
power source.
23
FX30
Gateway
1 Power
1
Power
3 On/Off
3
On/Off
I/O 1
I/O1
I/O 2
I/O2
I/O 3
I/O3
2 Ground
2
Ground
FX30
Gateway
1 Power
1
3 On/Off Power
I/O 1 On/Off
3
I/O 2
I/O1
I/O2
I/O 3
I/O3
2 Ground
2
Ground
Installation and Startup
Figure 2-15.
on
on page 59 for the radio
Figure 2-16 or
41110485