Chapter 4 Adjusting And Updating Settings As Required After Parts Replacement; If You Replace The Main Pcb Assy - Brother ADS-3000N Service Manual

CHAPTER 4 ADJUSTING AND UPDATING

1. IF YOU REPLACE THE MAIN PCB ASSY

<What to do after replacement>
• Installing firmware
• Setting by country
• Initializing the EEPROM of the main PCB ASSY
• Activating memory writing
• Setting serial number
• Setting multi feeding sensor threshold
• Check sensor operation
• Check multi feeding operation
• Checking operation after repair
• Resetting to factory shipping state
 What you need to prepare
(1) One USB cable
(2) Create a temporary folder on the C drive of the computer (Windows
(3) Service setting tool (brusbsn.zip)
Copy this file into the temporary folder created on the C drive.
(4) Download utility (Filedg32.exe)
Copy this file into the temporary folder created on the C drive.
(5) Maintenance driver (MaintenanceDriver.zip)
When the maintenance driver is not installed on the computer, copy this file into the
temporary folder created on the C drive, and extract the copied file. Refer to
3 INSTALLING THE MAINTENANCE PRINTER DRIVER"
(6) Firmware
Main firmware:
(E.g.) LZXXXX_$.djf
(7) Country code setting exe file
Copy this file into the temporary folder created on the C drive.
(8) Brother Utilities
(Install the product driver.)
(9) Sheet for multi feeding sensor threshold setting (LD6340001)
(10) Multi feeding sensor threshold setting tool (brADSmt1.exe)
Copy this file into the temporary folder created on the C drive.
(11) USB flash memory
(12) Calibration sheet (LD1914001)
(13) Memory access tool (MemoryAccessTool.exe)
(14) Shipping tool (ShippingTool.exe)
(15) Scan limit sample
(16) Test chart DS-001 (LD1625001)
SETTINGS AS REQUIRED
AFTER PARTS REPLACEMENT
LZXXXX : First six digits of the part number of the firmware
$ : Alphabetic character representing the revision version of the firmware
4-1
®
XP or higher).
"APPENDIX
to install.
Confidential