Omni Bead Ruptor 24 User Manual page 6

SECTION 2 — UNPACKING THE BEAD RUPTOR 24
Remove the warning sticker from the back of the unit and check that the voltage switch matches
the voltage delivered by your electric power supply.
Ensure that the air vents are not covered. Allow at least 6 inches of space around air vents for proper motor
ventilation.
CAUTION: DO NOT
connect the unit to the main power supply until installation is complete
and the correct voltage is selected.
Plug the Bead Ruptor 24 into the power supply using the supplied power cord.
In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric
current to reduce the risk of electric shock. This instrument is equipped with an electric cord which is
grounded to the chassis housing. The plug must be plugged in to an outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
WARNING: DO NOT
modify the plug or cord that is provided. Damaged or worn power cords should
be repaired or replaced immediately by a qualified electrician.
• DO NOT
turn the unit upside down: the Bead Ruptor 24 must always rest on all four feet to avoid
damaging internal components or breaking the housing.
• DO NOT operate the unit when the housing is removed; potentially lethal voltage exists within the instrument.
• DO NOT
operate the unit with the safety ground disconnected.
CAUTION:
Use only accessories and consumables recommended by the manufacturer.
Accuracy and operating lifetime may be affected if alternative products are used. Any damages caused
by non-recommended parts are not covered by the manufacturer's warranties.
6
CAUTION:
If the voltage supplied to the
equipment is higher than what is
indicated on the voltage switch,
the electronics can be irreversibly
damaged, voiding the warranty.