Page 3
Bead Ruptor Hub 1. Align slots in the center of the tube carriage to the ridges on the Bead Ruptor Hub. The “UP” marker should be at the top of the unit. 2. Place the lock ring on the hub.
Page 4
9 mL Cooling Unit. 8 mL 6 mL 5 mL TUBE COMPATIBILITY: Only use Omni International 15 mL conical tubes. 4 mL 3 mL The 15 mL Tube Carriage has been optimized for this tube geometry. 2m L 1 mL...
Troubleshooting In the instance that the lock ring or finger plate become stuck in the locked position, the Allen key must be inserted into the lock ring or finger plate as shown here. Use the Allen key to losen the Lock ring or Finger plate. Please call if further assistance is needed at 1-800-776-4431 Finger Plate Lock Ring...