Keypad Layout; Start Up Of The Equipment - Omni Bead Ruptor 24 User Manual

SECTION 4 — BEAD RUPTOR OPERATION

4.2 KEYPAD LAYOUT

The keypad of the Bead Ruptor 24 (see diagram below) consists of an LCD screen, 4 arrow buttons,
and a "RUN" and "STOP" button.
PROG >04
S=4.50
T=0:10

4.3 START UP OF THE EQUIPMENT

Turn the Bead Ruptor 24 on by pressing the ON/OFF switch located on the rear panel near the AC power input.
When the unit is turned on, a welcome screen is displayed for five seconds showing the following information:
From this screen the user can press and hold the  to select the display language. The user can choose from
F = French, E = English, G = German, I = Italian, S = Spanish.
After five seconds of the welcome screen, a menu displays the programming mode.
Programming mode displays the last program run before power was removed. Example:
Program Number
Speed in m/s
Cycle Time
• "S" = denotes speed in m/s and can be adjusted
from 0.8m/s to 8m/s in 0.15m/s increments.
• "T" = denotes the time in minutes:
seconds. Time can be set from 0:01 sec. to 9:59
minutes in 1 second increments.
20
20°C
C=02
D=0:10
READY
OMNI
INTERNATIONAL
BEAD RUPTOR 24
REV xx/xx/xxxx
PROG 01
S =4.50
T=0:10
System Status
The user can adjust four different homogenization
settings with this interface. The  UP and  DOWN
arrow buttons are used to navigate through the
menu and the  LEFT and  RIGHT arrow buttons
are used to adjust the parameters.
20 o C
C=02
D=0:10
READY
• "C" = denotes the number of times the cycle
(speed x time) is repeated; and can range
from 01 to 10 cycles.
• "D" = denotes the time interval in seconds
of dwell/pause between each cycle and can be
controlled from 0 seconds to 9:59 minutes.
Temperature inside chamber
in Celsius*
Number of Cycles
Time interval or Dwell
between each cycle