Omni Bead Ruptor 24 User Manual page 18

SECTION 4 — BEAD RUPTOR OPERATION
4.1 LOADING SAMPLE TUBES (cont.)
CAUTION:
The drive hub can become very hot during operation. Use caution when removing tubes from
the Tube Carriage / Tube Holders.
IDENTIFICATION OF PARTS:
7 mL Configuration
15 mL Configuration
18
7 mL Tube Carriage
Lock Ring
1. Place the tube carriage onto the Drive Hub.
2. Place Bead Ruptor 7 mL tubes into the
Tube Carriage.
3. Screw the locking ring on tightly.
4. Engage the lock.
CAUTION:
slightly while pressing on the lock to engage
properly. DO NOT exceed >6 m/s
15 mL Tube Carriage
Lock Ring
1. Place Bead Ruptor 15 mL tubes into the
Tube Carriage.
2. Place the tube carriage onto the
Drive Hub.
3. Screw the locking ring on tightly.
4. Engage the lock.
CAUTION:
You may need to turn the knob slightly while
pressing on the lock to engage
properly. DO NOT exceed >7 m/s
You may need to turn the knob