James Rebarscope R-C-400 Operator's Manual page 69

Warranty Information
1. Contract
Unless otherwise stated all sales transactions are expressly subject to these
terms and conditions. Modification or additions will be recognized only if
accepted in writing by an authorized Officer of James® Instruments Inc.
(hereinafter referred to as "James®" or the "Company"), or an officially
designated representative. PROVISIONS OF BUYER'S PURCHASE ORDER
OR OTHER DOCUMENTS THAT ADD TO OR DIFFER FROM THESE TERMS
AND CONDITIONS ARE EXPRESSLY REJECTED. NO WAIVER OF THESE
TERMS AND CONDITIONS OR ACCEPTANCE OF OTHERS SHALL BE
CONSTRUED AS FAILURE OF THE COMPANY TO RAISE OBJECTIONS.
2. Warranties
The Company only warrants the equipment manufactured or supplied by the
Company as set forth herein. James® makes no other warranties, either
expressed or implied
merchantability or fitness for a particular purpose). In no event shall James®
be liable for any type of special, consequential, incidental, or penal
damages, whether such damages arise out of or are a result of breach of
contract, warranty, negligence, strict liability or otherwise. Warranty shall not
apply where the equipment manufactured or supplied has been subject to
accident, alteration, misuse, abuse, improper storage, packing, force majeure,
improper operation, installation, or servicing. In addition, the following shall
constitute the sole and exclusive remedies of Buyer for any breach by James®
of its warranty hereunder.
a. New Products
James® warrants the equipment manufactured or supplied by
James® as set forth herein. This limited warranty can only be
exercised by the original purchaser of the equipment from James® or
authorized James® Agent and is not transferable to any subsequent
owner or party. This limited warranty gives you specific legal rights,
and you may also have other rights which vary from case to case.
www.ndtJames.com
(including
i. For James® Equipment
James® warrants that James's equipment will be free
from defects in materials and workmanship for a period of
twenty- four (24) months on the electronic portion and six (6)
months on the mechanical portion from the date of shipment
of equipment from James® to Buyer. Should any defects
be found and reported by the Buyer during the applicable
limited warranty period, the defect will be corrected upon
return of the item to James®. James® will, during the
applicable new equipment warranty period, provide the
necessary replacement parts and labor to correct the defect.
Excluded from the new equipment warranty are all
without limitation,
64
warranties as to