James Rebarscope R-C-400 Operator's Manual page 45

Figure 39: Scan Cart Diagram
Step 13: Position scan cart at beginning of area to be analyzed.
Step 14: Press Enter on Rebarscope® Front Panel. The display will
now read "Scanner is ON", and the user is ready to start testing.
Step 15: Measuring from the front of the scan cart, begin pushing
the cart at a very slow pace from the starting point; using the
extended handle. (See picture below.)
Step 16: Remain at this same pace until Rebarscope® notifies the
end of scan by producing an end beep noise.
Step 17: The Rebarscope® does not present real time data of a
scan, it is necessary to back the cursor toward the start point to
view data. The results will be displayed in a B-Scan diagram.
40
www.ndtJames.com