Short / Deep Mode - James Rebarscope R-C-400 Operator's Manual

Short / Deep Mode

The Rebarscope® facilitates the analysis of rebar location, cover
and bar sizing; allowing the user to do measurements in short mode
or deep mode. The Rebarscope® also provides the user the ability
to automatically switch between deep and/or short mode.
Note: The single sensing probe operates efficiently in both modes.
When the system is initially turned "on", the Automatic (RS) mode is
the default setting. To change this, go to the Locate Cover screen.
• Once in the Locate Cover screen, use the up or down arrow keys
on the front panel to highlight the graphic bar .
• When the highlight is on the bar, press the left arrow key to
change between modes. (Note: The letters RS in the upper left
hand corner of the screen indicate auto ranging is "on".)
• Follow the procedure above to turn off Auto ranging, and to
manually switch between Deep and Short modes as seen on line 1
of this screen.
Figure 5: Locate Cover Screen
11
www.ndtJames.com