James Rebarscope R-C-400 Operator's Manual page 65

To find the correct Comport to use, follow the steps below...
1. Go to the PC's Device Manager... Start button / Control Panel /
Device Manager / Ports.
2. Connect the USB cable to the unit. Then, while viewing the
'Ports' directory, connect the USB cable to one of the PC's USB
ports. The correct Comport setting will become visible in the 'Ports"
directory.
3. When the correct Comport is found, go to the James®
software, and click on 'Tools' in the task bar (at the top). Select
the correct Comport (1-20) from the drop down list.
4. Go back to the unit and select the Test Data to upload.
5. Go back again to the software, and click on the Lightning Bolt
icon in the task bar...
6. Now press 'Enter' on the unit to start the upload process. The PC
should say the computer is "Receiving Data".
If these steps do not work, it is possible the correct Drivers need to
be installed on the PC. Go to the following website for more help...
http://www.ftdichip.com/Drivers/D2XX.htm
(Note: Although James® does not support Windows XP (any
longer), the data handler should still work with XP.)
60
www.ndtJames.com