James Rebarscope R-C-400 Operator's Manual page 32

Step 3: Choose whether you would like to INSTALL NEW MAP or
VIEW OLD MAP by highlighting one and pressing Enter.
Figure 25: Install New Map or View Old Map
Step 4: If View Old Map is chosen please proceed to step 4B, if not
please follow the instruction directly below for installation of a new
map.
Figure 26: Map Display
Step 4A:
1 The Rebarscope® automatically generates a map number.
2 Under the Material category line, choose the material under
investigation. (rebar, conduit, copper)
3. Choose the diameter of the material under investigation.
4. Choose the S min (minimum cover)
27
www.ndtJames.com