Running The Cleaning Program - Cuisinart Veloce EM1000U Manual

6 .10 Running the cleaning program

The cleaning program enables intensive cleaning of otherwise inaccessible areas.
You should run the cleaning program monthly, however at the latest, when the following
appears in the display:
Run the cleaning program as follows:
In the main menu, press the
Now press the
Fill the water tank to the maximum filling level.
Put a cleaning tablet* into the ground coffee chute. (9). You do not need to empty the
bean container.
Follow the instructions and confirm by pressing the
NOTE
* Commercial cleaning tablets are available in most stores or online where espresso
units are sold.
The cleaning process takes approx. 8 minutes and should not be interrupted.
In case of power failure during the cleaning program, it has to be restarted.
Before running the cleaning program, the metal sieves in the brewing unit must be
clean and wiped dry. (See Section 6.9)
The water is collected in the drip tray. Alternatively, you can place a receptacle (350ml)
under the spout. Only empty the receptacle when the coffee machine indicates that the
drip tray must emptied.
ATTENTION
Damage to the coffee machine and remnants left in the water by use of the wrong
cleaner!
Use only commercial cleaning tablets intended for fully automatic espresso machines.
If other cleaning solutions are used, CUISINART assumes no liability for any damage
caused.
As soon as the cleaning program is completed, the coffee machine is ready for operation
and in the same state as the last-selected coffee mode.
Remove the water tank and fill with fresh water. Insert the water tank again.
Now prepare a cup of coffee and pour it away in the sink to eliminate any remaining
residues of the cleaning tablet.
button.
button.
57
button.