Cuisinart Veloce EM1000U Manual page 70

Problem
Water in the waste
container.
Coffee dispensing too
slow.
Water runs into the
waste container
during rinsing when
switching the coffee
machine on and off.
Coffee machine
cannot be switched
on.
Coffee dispensing is
very uneven or only
one-sided.
Coffee is very watery
or only hot water.
NOTE
If you cannot resolve the problem with the steps described above, please contact
customer service.
The free service hotline number: 0370 2406902
Cause
• Water leaks into the
waste container during
each rinsing process.
• Grinding fineness set too
fine.
• Grinding quantity set too
high.
• Water system clogged.
• Brewing unit is blocked or
maladjusted.
• Mains plug not plugged
in.
• Spout is clogged or
blocked by foreign matter
(e.g., coffee bean or
similar).
• Coffee shaft is blocked by
coffee grounds.
70
Remedy
• This is normal, it occurs during
the cleaning of the internal
mechanism.
• Set coarser grinding fineness.
• Set ground coffee quantity
lower.
• Run the descaling program.
• Adjust the brewing unit.
See also 6.9
• Plug the mains plug in.
• Pull the coffee spout upwards
and clean the inside or remove
the foreign matter (e.g.,
coffee bean). See section 6 .6 .
Removing and cleaning the
coffee dispensing unit
• Remove the brewing unit. Clean
the coffee shaft by pushing a
suitable (round) brush through
the ground coffee chamber
opening.