Using The Hot Water Function; Cleaning And Maintenance - Cuisinart EM-100N Series Instruction Booklet

7. As the steam heats and
textures the milk, the
level of the milk in the
pitcher will begin to rise.
As this happens, follow
the level of the milk by
lowering the pitcher,
always keeping the tip
of the steam nozzle just
below the surface.
8. Once the foam is created,
raise the pitcher until the
steam nozzle is in the
center of the milk (25).
TIP: The amount of foam
required will vary
depending on the drinks
being made; for example,
a cappuccino requires
more foam than a latte.
9. Stop the steam
immediately when the milk is heated by
turning the large function knob to the off
position (26).
IMPORTANT: Do not boil the milk.
10. Remove the pitcher, immediately wipe
the
steam nozzle and wand with a clean
damp cloth (27) and purge a small
amount of steam.
USING THE HOT WATER
FUNCTION
When using the hot water function make sure
that the steam/hot water knob is in the
hot water setting.
1. Place the cup or
container under the
steam/hot water nozzle
and turn the function
knob to the
(28).
2. Once you have
dispensed the required
amount of hot water into the cup or
container, stop the hot water by turning
the large function knob to the off position
(29).
setting
25
3. Remove the cup or container and swing
26
the steam/hot water wand over the drip
tray to catch any drips of water (30).
CLEANING AND
MAINTENANCE
Always turn the Espresso Maker off and
27
remove the plug from the electrical outlet
before cleaning.
Never immerse unit in water or other liquid.
To clean, simply wipe with a clean damp
cloth and dry before storing.
CLEANING THE FILTERS, PORTAFILTER
HOLDER AND BREW HEAD
• The stainless steel filters and portafilter
holder should be rinsed under water
immediately after use to remove all coffee
particles. You may also use a cleaning pin
to clean the opening.
• Periodically run water through the
machine with the portafilter holder in
place, but without any ground coffee, to
rinse out any lingering coffee particles.
The inside of the brew head should be
wiped with a damp cloth to remove any
coffee particles.
CLEANING THE OUTER HOUSING/CUP
WARMING PLATE
• The outer housing and cup warming plate
can be cleaned with a soft, damp cloth.
28
Do not use any scouring agents or harsh
cleaners.
CLEANING THE DRIP TRAY
• The drip tray can be removed after the
grate is removed and then cleaned with a
soft, damp cloth. Do not use any scouring
agents or harsh cleaners.
• The drip tray can be washed in warm
soapy water and rinsed thoroughly. Use a
non-abrasive washing liquid. Do not use
any scouring agents or harsh cleaners.
9
29
30