Filling With Water - Cuisinart Veloce EM1000U Manual

2 .4 Filling with water

CAUTION
Milk, mineral water or other liquids can damage the water tank or the coffee machine.
Only fill the water tank with fresh, cold water.
Observe the maximum filling level of 1.25 litres.
During initial startup (or when the water tank was previously emptied completely),
water intake can be slowed down. In this case, it is helpful to switch the device off
and on again.
To fill the water tank, proceed as follows:
Push the coffee dispensing unit (3) into the uppermost position.
Remove the water tank (6) from the appliance.
Fill the water tank with fresh water up to its maximum fill level.
Replace the water tank. Push it until it snaps in.
NOTE
If the following warning appears on the display, the water tank must be topped up
before the next drink is dispensed. Otherwise further function is not possible:
Before inserting the water tank, make sure that it is dry on the outside. Wipe the water
tank shaft dry also before inserting the water tank.
14