At Power-Up And On Reset - Sundance Spas SMT370v2 User Manual

Version 1.0
NET "SHBA<11>" LOC = "J1"
NET "SHBA<10>" LOC = "J2"
NET "SHBA<9>" LOC = "J3"
NET "SHBA<8>" LOC = "J4"
NET "SHBA<7>" LOC = "H1"
NET "SHBA<6>" LOC = "H2"

At power-up and on reset.

At power-up, the FPGA is not configured and is waiting for a bit stream to be loaded.
By fitting Jumper J8 (Figure 9 - Connector Location.), it will allow the bit stream
stored into the PROM to be loaded into the FPGA at power-up and after every TIM
reset.
If J8 is not fitted, nothing happens. This condition is useful when needing to configure
the FPGA via JTAG.
Page 23 of 44
;
;
;
;
;
;
NET "SHBA<5>" LOC = "H3"
NET "SHBA<4>" LOC = "H4"
NET "SHBA<3>" LOC = "J6"
NET "SHBA<2>" LOC = "H5"
NET "SHBA<1>" LOC = "G1"
NET "SHBA<0>" LOC = "G2"
SMT370v2 User Manual
;
;
;
;
;
;