Measuring With The Powermonitor Software Pms; Safety Instructions - Primes CompactPowerMonitor Series Operating Manual

CompactPowerMonitor CPM
13

Measuring with the PowerMonitor Software PMS

13.1

Safety instructions

DANGER
Serious eye or skin injury due to laser radiation
During the measurement the laser beam is guided on the device, which causes scattered or
directed reflection of the laser beam (laser class 4).
For example, with 10 kW of laser power, some 100 W of scattered radiation can occur.
The CompactPowerMonitor CPM must not be operated in any of the available configura-
tions without taking the following precautions.
X Please wear safety goggles adapted to the power, power density, laser wave length and
operating mode of the laser beam source in use.
X Wear suitable protective clothing and protective gloves.
X Protect yourself from laser radiation by separating protective devices (e.g. by using appro-
priate shielding).
DANGER
Serious eye or skin injury due to laser radiation
If the device is moved from its calibrated position, increased scattered or directed reflection
of the laser beam occurs during measuring operation (laser class 4).
X When mounting the device, please ensure that it cannot be moved, neither due to an unin-
tended push or a pull on the cables or hoses.
DANGER
Fire hazard; Damage/Destruction of the device due to overheating
If the safety interlock is not connected, the unit may overheat and be damaged or catch fire
if there is no water or too low flow.
X Connect the laser control's safety interlock to the device. Check that the safety interlock will
switch off the laser properly in case of error.
WARNUNG
Burn hazard; Damage of the absorber – Do not touch
Touching the hot absorber can cause severe burns.
Touching the absorber can lead to burn-in by the laser radiation at the points of contact.
Burn-in lead to damage to the absorber and increase the scattered radiation.
X Do not touch the absorber.
Revision 02/2019 EN 41