Table of Contents
Advertisement
CompactPowerMonitor CPM
11.2
Getting ready for operation
1. Connect the laser control's safety interlock to the device.
•
Check that the safety interlock will switch off the laser properly in case of error.
2. Turn on the voltage supply.
•
The green status display (Ready) must light up.
3. Please wait, until the measured value display is illuminated.
4. Turn on the water cooling.
•
After a few seconds the red status display (Error) must extinguish.
5. After approx. 2 minutes, the device temperature equals the temperature of the cooling water.
•
The CompactPowerMonitor CPM is now ready for operation.
11.3
Perform power measurement
For the purpose of getting to know the CompactPowerMonitor CPM, this chapter describes a power mea-
surement with the LaserDiagnosticsSoftware LDS as an example.
For a detailed description of the software installation, file management and evaluation of the measured data,
please refer to the separate operating manual LaserDiagnosticsSoftware LDS.
11.3.1
Connect the CompactPowerMonitor CPM with the LaserDiagnosticsSoftware LDS
1.
Start the LaserDiagnosticsSoft-
ware LDS.
2.
Click on the Devices tab.
3.
Click on the + Connect to device
button under the tab.
The Connections window appears.
4.
Click on the desired device.
5.
Click on the Connect to device but-
ton.
Revision 02/2019 EN
35
Advertisement
Table of Contents
