Installation & Set-Up - Dixie Narco 90 Series Operation Manual

INSTALLATION - SERIES 90 CAN & BOTTLE VENDER
Upon receipt, inspect the vender for shipping damage. If there is any damage, have the driver note the
damage on the Bill of Lading and notify Dixie-Narco. Although the terms of the vender sale require that
the consignee originate shipping damage claims, Dixie-Narco will gladly help if you must file a claim.
Remove the stretch wrap and top covers from the vender. If flavor cards were shipped with the vender,
they will be in an envelope affixed to the back of a vender in the shipment or in the cash box.
NOTE: DO NOT STORE THE VENDER OUTSIDE WITH STRETCH WRAP ON. THIS
COULD CAUSE THE STRETCH WRAP TO BOND TO THE VENDER'S
SURFACE, WHICH COULD DAMAGE THE FINISH.
Remove the shipping boards from the bottom of the vender. The shipping boards are attached by the
leveling legs. Remove the shipping boards by unscrewing the leveling legs. A 1½" "socket-type"
wrench should be used on the bottom of the leveling legs. Be sure to replace the legs after removing the
shipping boards.
To open the vender, locate the door lock keys which are secured inside the coin return cup. After
unlocking the door, rotate the "T"-handle counter-clockwise until the door can be opened. Once inside,
check the coin box on the door for any additional parts, pricing labels, or information concerning factory
equipped accessories. Check the "T"-handle for proper alignment and locking functions. Check the
lamps for proper installation.
WARNING: ENSURE THAT POWER IS DISCONNECTED FROM THE VENDER OR
THAT THE POWER INTERRUPT SWITCH (IF PROVIDED) IS NOT DEFEATED
BEFORE INSPECTING OR REPLACING THE LAMPS. FAILURE TO COMPLY WITH
THESE INSTRUCTIONS MAY SUBJECT THE USER TO THE RISK OF INJURY OR
ELECTRICAL SHOCK, WHICH CAN BE SERIOUS OR FATAL.
Refer to the vender serial number plate to determine the proper voltage and frequency the machine
requires (domestically this requirement is 115 volt, 60 hertz). Domestic venders will operate at +/- 10%
of the specified voltage. For domestic models this is between 103 volts and 127 volts. The cabinet
serial plate also indicates the amperage of the vender. Single phase, alternating current is required. The
vender must be plugged in its own properly rated circuit with its own circuit protection (fuse/circuit
breaker).
DO NOT USE AN EXTENSION CORD.
Page 4 of 72
INSTALLATION & SET-UP
RECEIVING INSPECTION
UNPACKING THE VENDER
ELECTRIC POWER NEEDED