Troubleshooting; Siid Vending - Dixie Narco 90 Series Operation Manual
Single price / siid e-model venders
Hide thumbs
Also See for 90 Series:
- Installation and setup manual (8 pages) ,
- Service manual (39 pages)
Table of Contents
Advertisement
1.
Problem:
Free vend on one column.
Troubleshooting:
2.
Problem:
One motor continues to home with door closed, shows "JC#" when in diagnostics or "COLJ" when "ErOr"
routine is entered.
Troubleshooting:
3.
Problem:
One column sold out, but still vends.
Troubleshooting:
4.
Problem:
Vender will not sequence (Coca-Cola only).
Troubleshooting:
5.
Problem:
Free vend on one or more columns.
Troubleshooting:
6.
Problem:
Column Jackpots.
Troubleshooting:
7.
Problem:
Column will not vend.
Troubleshooting:
8.
Problem:
Motor stops on high cam.
Troubleshooting:
Set-up subject to change without notice. For packages not listed contact Dixie-Narco Factory
Service at (800) 688-9090.
TROUBLESHOOTING
SIID VENDING
A)
Check selection price.
B)
Check for bad connections or broken, backed out, or crossed wires from vend motor to control
board.
C)
Check for sticking select button.
D)
Check control board.
A)
If using Mars Validator, ensure correct interface harness is used.
B)
Check for bad connections or broken, backed out, or crossed wires from vend motor to control
board. (Note: Check wires on left side of vend motor cover.)
C)
Vend switch.
D)
Check control board.
A)
Check sold-out switch.
B)
Check for bad connections or broken, backed out, or crossed wires from sold-out switch to
control board. (Note: Check wires on left side of vend motor cover.)
A)
Ensure wire #24 is in select panel harness and is in correct pin location.
B)
Check for bad connection or broken wire #24 in select panel harness.
C)
Make sure wire #24 is in correct location.
D)
Check control board.
A)
Check secondary pricing program.
B)
Check for bad connections or broken, backed out, or crossed wires from vend motor to control
board.
C)
Check for sticking select button.
D)
Check for bad vend motor switch.
E)
Check control board.
A)
Check problem column(s) in motor test.
B)
Check motor for:
1.
Syrup on brake.
2.
Locate/check brake spring.
3.
Check motor switch.
C)
Check wiring from/to motor switch of problem column.
D)
Check wiring at mate-n-lock on cabinet harness and cabinet extension harness.
E)
Check motor.
F)
Check control board.
A)
Go to diagnostics and test.
B)
Check for bad connection or broken, backed out, or crossed wires.
(Also check ballast wires)
A)
Change vend switch.
B)
Install current software.
-5 or 380.11 or greater two-button programming.
Page 40 of 72
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
