Siid Sold Out; Siid Select Panel / Display - Dixie Narco 90 Series Operation Manual
Single price / siid e-model venders
Hide thumbs
Also See for 90 Series:
- Installation and setup manual (8 pages) ,
- Service manual (39 pages)
Table of Contents
Advertisement
1.
Problem:
Sold-out message stays on.
Troubleshooting:
2.
Problem:
Sold-out message comes on with product in column.
Troubleshooting:
3.
Problem:
Sold-out switches work the incorrect column.
Troubleshooting:
1.
Problem:
Plug in vender and displays a blank or "rrrr" appears on the display; vender will not function.
Troubleshooting:
2.
Problem:
Display will not function.
Troubleshooting:
3.
Problem:
Display shows $1 and then increases in dollar increments with door closed
Troubleshooting:
4.
Problem:
Cannot set price on a given selection.
Troubleshooting:
5.
Problem:
Vender changes a set vend price to .10¢ on selections on its own. (domestic only - .10¢ could be any given
price.)
Troubleshooting:
6.
Problem:
Control board looses its memory when power is shut off to vender.
Troubleshooting:
Page 45 of 72
SIID SOLD-OUT MESSAGE
A)
Check limited access program.
B)
Check for crossed wires in cabinet harness and cabinet extension harness or loose wire
harness connection.
C)
Check for motors rubbing motor cover (on early SIID venders).
A)
Check programming and ensure limited access is not on.
B)
Check for bad connections or broken, backed out, or crossed wires from select switch to
control board.
(Note: Check wires on left side of motor cover.)
C)
Check for motor rubbing motor cover (on early SIID venders).
A)
Ensure correct cabinet harness and select harness are being used.
B)
Check for crossed wires in cabinet harness or cabinet extension harness.
SIID SELECT PANEL / DISPLAY
A)
Press a select button to change message on display; this should clear.
B)
Remove power to vender for one minute, then power vender back up.
C)
Check main power plug for loose connection.
D)
Check for bad connections or broken wires from display to control board.
E)
Check display board.
F)
Check control board.
A)
Check for bad connections or broken wires from display to control board.
B)
Check F1 board power fuse (1.6 amp).
C)
Check display board.
D)
Check transformer.
E)
Check control board.
A)
Check coin mech.
B)
Check validator
C)
Check control board.
A)
Check configuration code 1 is set to C1 1 (multi-pricing). (4-button programming only)
B)
Check for bad connections or broken wires from select switch to control board.
C)
Check select switches.
D)
Check control board.
A)
Check secondary pricing program.
B)
Check for bad connections or broken wires from select switch to control board.
C)
Check control board. (Possible cold solder joints.)
A)
Check battery (see problem 16 on next page).
B)
Check control board.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
