Power Over Ethernet Plus (Poe+); Cable Requirements - Shure IntelliMix P300 Safety Information Manual

Safety Information
Installing Underneath a Table
1. Hold the tray in the desired location under a table
2. Use a pencil to mark the location of the mounting holes on the table.
3. Drill 4 holes for the screws. The diameter of the holes in the tray are 7.1 mm.
4. Install the components into the tray
5. Install with 4 screws to secure the tray underneath the table

Power Over Ethernet Plus (PoE+)

This device requires PoE Plus to operate. It is compatible with both Class 4 PoE+ sources.
Power over Ethernet is delivered in one of the following ways:
• A network switch that provides PoE+
• A PoE+ injector device (must be a Gigabit device)

Cable Requirements

Always use Cat5E cable or higher.
Reset
The reset button is located inside a small hole in the rear panel. Use a paperclip or other small tool to press the
button.
There are two hardware reset functions:
Network reset (press but­
ton for 4-8 seconds)
Resets all Shure control and audio network IP settings to factory defaults
Shure Incorporated
20/96