Step 1: Connect To A Network - Shure IntelliMix P300 Safety Information Manual

Safety Information
Getting Started
This device features a browser-based web application, which controls audio and network properties. Upon com­
pleting this basic setup process, you will be able to:
• Access the web application to customize audio settings, signal routing, and network properties
• Use Dante Controller software to connect with other Dante devices and pass audio
• Access additional configuration information

Step 1: Connect to a Network

1. Use an Ethernet cable (CAT5e or higher) to connect the P300 to a network switch.
Note: The network switch must provide Power over Ethernet Plus (PoE+). Make sure to connect to a PoE+
port, since many switches do not supply power on all ports.
2. Connect a computer to the network switch with an Ethernet cable
Step 2: Access the Web Application
1. Download and install the Shure Device Discovery application (http://www.shure.com)
2. Open the Shure Device Discovery application
3. Double-click the device to open the web application.
Tip: If setting up multiple Shure devices, use the Identify button in the application to flash the lights on the de­
vice.
Shure Incorporated
3/96