Device Ip Settings; Configuring Ip Settings - Shure IntelliMix P300 Safety Information Manual

Safety Information
• Devices on separate networks require an audio processor or conferencing software to carry audio between
them. See the system planning and gear requirements section for network setup information and configuration
examples.
• Use only 1 DHCP server per network. Disable DHCP addressing on additional servers.
• Power on the switch and DHCP server prior to MXA equipment.
• To expand the network, use multiple Ethernet switches in a star topology.
• All devices must be at the same firmware revision level.
Network Audio and Shure Control Data
MicroflexAdvance devices transport two types of data over the network: Shure Control and Network Audio.
Shure Control
The Shure Control carries data for the control software operation, firmware updates and 3rd party control systems
(AMX, Crestron).
Network Audio
This network carries both the Dante digital audio and the control data for Dante Controller. The network audio re­
quires a wired, gigabit Ethernet connection to operate.

Device IP Settings

Configure IP
Sets IP mode of the selected network interface:
• Auto (DHCP): For automatic assignment of IP addresses.
• Manual (Static): For Static IP addresses.
IP Settings
View and edit the IP Address, Subnet Mask, and Gateway for each network interface.
MAC Address
The network interface's unique identification.

Configuring IP Settings

IP configurations are managed through the web application. By default, they are set to Automatic (DHCP) mode.
DHCP mode enables the devices to accept IP settings from a DHCP server, or automatically fall back to Link-Local
settings when no DHCP is available. IP addresses may also be manually set.
Shure Incorporated
36/96