Manually Assigning Static Ip Address - Shure IntelliMix P300 Safety Information Manual

Safety Information
To configure the IP properties, follow these steps:
1. Open the web application.
2. Go to the Settings tab and select Network.
3. Select Auto or Manual. If Auto is used, addresses will be automatically assigned. For Manual setup, follow the
instructions on manual configuration.

Manually Assigning Static IP Address

To manually assign IP addresses, follow these steps:
1. Open the web application.
2. Go to the Settings tab and select Network.
3. Select Manual as the Configure IP setting.
4. Enter the IP settings.
Operating the Control Software over Wi-Fi
When operating the web application over Wi­Fi, it's important to set up the wireless router properly for best perfor­
mance. The system employs several standard-based protocols that rely on multicast. Wi-Fi treats broadcast and
multicast packets differently than general packets for backward compatibility reasons. In some cases, the Wi-Fi
router will limit the multicast packet transmission rate to a value that is too slow for web application to properly op­
erate.
Wi-Fi routers typically support 802.11b, 802.11a/g, and/or 802.11n standards. By default, many Wi-Fi routers are
configured to allow older 802.11b devices to operate over the network. In this configuration, these routers will auto­
matically limit the multicast data rates (or sometimes referred to as 'basic rate', or 'management rate') to 1­2Mbps.
Note: A Wi-Fi connection can only be used for the control software. Network audio cannot be transmitted over Wi-
Fi.
Tip: For larger wireless microphone configurations, it's recommended to increase the multicast transmission rate
to provide adequate bandwidth.
Important: For best performance, use a Wi-Fi router that does not limit the multicast rate to 1-2 Mbps.
Shure recommends the following Wi-Fi router brands:
• Cisco
• Linksys
• Apple
Shure Incorporated
37/96