Energize6 Service Manual
S
A
ERVICE
CCESS
Main Service Panel
Publication Number: 621058457SER
COMPONENT SERVICE
!
WARNING:
Only trained and certified electrical, plumbing and refrigeration technicians should
service this unit.
ALL WIRING AND PLUMBING MUST CONFORM TO NATIONAL AND LOCAL
CODES. FAILURE TO COMPLY COULD RESULT IN SERIOUS INJURY, DEATH
OR EQUIPMENT DAMAGE.
!
WARNING:
Disconnect power to the unit before servicing. Follow all lock out/tag out procedures
established by the user. Verify all power is off to the unit before performing any work.
Failure to comply could result in serious injury, death or damage
to the equipment.
!
CAUTION:
All of the threaded plumbing connections in the system contain a plastic gasket to
ensure a proper seal when the connection is tightened. MAKE SURE TO REPLACE
THIS GASKET WHENEVER A CONNECTION IS OPENED FOR REPAIR.
The following procedures describes how to access portions of the unit under the
main service panel.
To remove the main service panel, perform the procedure in Table 13.
Step
Remove the cover using the procedure in "Removing the Unit Cover" on
1
page 14.
Using a Phillips screwdriver, remove the seven screws around the edges of
2
the service panel, shown in Figure 12 and Figure 13.
3
Lift the service panel away from the base of the Energize6 unit.
- 18 -
Table 13.
Action this
© 2012, IMI Cornelius Inc.