Table of Contents
Advertisement
Energize6 Service Manual
Q
UARTERLY
Beverage Tubing
Water Filters
Syrup Supply
Publication Number: 621058457SER
Step
1
Remove all the quick disconnects from all the B-I-B containers.
2
Fill a 1-gallon bucket with mild detergent solution.
Submerge all disconnects in the soap solution and then clean them using a
3
nylon bristle brush. (Do not use a wire brush). Rinse them with clean water.
4
Using a plastic pail, prepare approximately five (5) gallons of sanitizing solution.
5
Rinse the B-I-B disconnects in the sanitizing solution.
Repeat Steps 1-5 for all BIB connectors on the rack. Discard the remaining
6
water from the bucket.
• Inspect beverage tubing for damage. Re-insulate and seal any uninsu-
lated or damaged tubing.
• Inspect python channels and seal any open channel ends.
• Inspect and clean the grills and condenser fins located on the remote
condenser, if necessary.
• Verify that water pressure is between 20 psi (1,4 bar) and 120 psi (8,3
bar). If the pressure is low, inspect the water filter cartridges to ensure
that they are able to supply adequate water pressure under normal sys-
tem flow. Replace them if they are unable to provide the minimum pres-
sure under load.
• If equipped with a water regulator, verify that it is set to 55 psi (3,8 bar).
Adjust the setting as needed.
The syrup supplies should be inspected and cleaned using the procedure in Table 5.
Step
Inspect syrup lines for the proper flavor identification labels. Replace the labels
1
as needed.
2
Disconnect and remove the syrup containers.
3
Clean the connectors with soap and warm water. Rinse them with plain water.
4
Return the syrup containers and reconnect them.
- 12 -
Table 4.
Action
Table 5.
Action
© 2012, IMI Cornelius Inc.
Advertisement
Table of Contents
