Table of Contents
Advertisement
Analog Input SmartLead
Attention
•
The Ultium Analog Input SmartLead (both versions) provides a single, shared Ground wire.
The operator must ensure that the system they are attaching to is compatible with this
configuration.
6.4 Component Interconnections
Analog Input SmartLead: 2.5mm TRSS Mating Connector Version:
Step 1A
Step 1B
Open Wire Version:
Step 1A
P-811 Rev B (May 2019)
Connect the Ultium Sensor to
the Ultium Analog Input
SmartLead. The Status LED
will flash Violet 3 times if the
SmartLead was successfully
detected. If the LED is solid
Yellow, see the
Troubleshooting section of this
manual.
Connect the Ultium Analog
Input SmartLead to the 2.5 mm
TRSS Mating Connector. To
connect the connector to the
desired signal, refer to 'Signal
Source Setup' above.
Connect the Ultium Sensor to
the Ultium Analog Input
SmartLead. The Status LED will
flash Violet 3 times if the
SmartLead was successfully
detected. If the LED is solid
11
Advertisement
Table of Contents
