Component Interconnections - Noraxon Ultium 808 User Manual

2D Goniometer SmartLead User Manual

5.3 Component Interconnections

(Rev D January 2020)
Serial Number – Unique 5-
character serial number
which identifies each EMG
sensor.
2D Goniometer
SmartLead
Serial Number: Unique 5-
character serial number
which identifies each
SmartLead.
Step 1
Connect the 2D Goniometer SmartLead
to the Ultium Designated Ultium Sensor
(See 'MR3 Configuration' Section below
for instructions on how to designate a
SmartLead to a specific Ultium Sensor)
Step 2
Connect the 4-pin plugs of the 2D
Goniometer SmartLeads to the X-Y
Goniometer Sensor sockets. The Ultium
SmartLead and the Goniometer sensor
lead with the green tape are the x-axis.
Insert the Ultium SmartLead plug with
the green tape into the Goniometer
sensor socket with green tape. Do the
same for the gray (unmarked) leads. *
10