Table of Contents
Advertisement
Analog Input SmartLead
9 Accessories and Optional Modules
9.1 Accessories
The Analog Input SmartLead is either open wired (displayed in Section 6 – no accessories) or used
in conjunction with a 2.5 mm TRRS Mating Connector as displayed below.
10 Cleaning
10.1 Safety Precautions When Cleaning
WARNING
Only use a damp cloth with mild soap and water or isopropyl alcohol to clean the Ultium
SmartLeads.
Do not immerse Ultium Sensors or SmartLeads in any water or liquid.
11 Maintenance
11.1 Device Software (firmware) updates
The internal program (firmware) inside the various Ultium devices can be updated via MR3. The
user will be notified within the Ultium System hardware setup if an update is required. Ensure that
all sensors are placed in the Ultium charging doc and that the charging doc is connected to the
Ultium receiver prior to initiating the firmware update. If you start the update prior to completing
this step, you may need to update again (firmware update button will still be present in hardware
setup).
P-811 Rev B (May 2019)
22
Advertisement
Table of Contents
