Pre-Use Check-Out; Normal Appearance Of Signals - Noraxon Ultium EMG Analog Input SmartLead User Manual

Analog Input SmartLead

7 Pre-Use Check-Out

7.1 Normal Appearance of Signals

The sensor's STATUS LED provides a means of communicating its operational state. In the idle
state, the STATUS LED will flash blue at a low, once per second rate. When the sensor is actively
measuring a signal, the STATUS LED will flash recognizably faster (green).
Quick Testing:
To ensure that the Analog Input SmartLead is wired properly, each of the signals can be wired to a
known voltage in series as demonstrated below with a 1.5 Volt signal.
P-811 Rev B (May 2019)
19