Noraxon Ultium EMG Analog Input SmartLead User Manual page 16

Analog Input SmartLead
6.7.2 Find My Sensor Feature
Allows the user to quickly locate a specified Ultium sensor while creating/editing a MR3
configuration (refer to section 7 for guidance on how to create or edit a configuration). If one of the
stars (refer to the figure below) is clicked, the corresponding sensor will repeatedly blink light purple
P-811 Rev B (May 2019)
Step 5a
Once the Ultium system is
inserted, the muscle map
will appear to the left, and
the EMG channels and
sensors will appear below.
The Ultium Analog Input
SmartLead should
automatically appear, as
detected by the Ultium
system (if it does not –
refer to step 2a). If you
would like to change the
sensor type for the Analog
Input SmartLead, refer to
the below protocol. **
To select the Analog Input
SmartLead for use in a
recording, check the box
next to the Analog Input
channel. If one would like
to customize the input
from the Analog Input
SmartLead (designate the
signal type and the units),
refer to the below
instructions. **
Step 5b
Continue with the
measurement setup as
described in the Noraxon
system's hardware
manual.
16