Adjusting The Height Of The Push Rod - Keysight Technologies PD1000A Operating Manual

Keysight SMD Fixture
with SMA Connectors.
Vertically conductive sheet
Frame guide to place SMD
Custom Single-sided
PC Board
Figure 23 Assembling the SMD Test Fixture

Adjusting the Height of the Push Rod

You can adjust the height (and thereby the force that the push rod exerts on the
SMD device) of the push rod on the test fixture by loosening the 1.5 mm hex
socket (Allen) set screw on the side of the push rod head and sliding the head up
or down then tightening the set screw. See the figure below.
Figure 24 Allen Screw to Adjust the Height of the Push Rod
36
Customizing an SMD Test Fixture
Keysight PD1000A Test Fixture Operating Guide